Control Of The Tv - Sharp Aquos LC-80UH30U Setup Manual

EJ
Using a PC
EJ
Control of the TV
• The TV can be controlled from a PC. control panels and other dev ices
using the RS-232C.
• Use a cross-type RS-232C cable (commercially available) for the
connections.
• This operation system should be used by a person who is
accustomed to using computers.
AQUOS Remote Control
Set this function when operating the TV from equipment connected by
LAN or wireless LAN. To perform the operation. refer to "TV Setup">
"General".
Rem ote Control App
When "Remote Control App" is selected, "Change" w ill be highlighted.
Press
e
(ENTER).
Det ailed Settings
Make the detailed settings (Login I D. Password).
Follow the on-screen instructions to configure the settings.
Devieename
Set the name of the TV displayed on other network devices.
Configure the settings from "HOME" > "Settings"> "Dev ice· > "About">
"Device name· .
Communication Conditions for RS-232C
Set the RS-232C communication settings on the PC to match the TV's
communication conditions.
Th TV' ·
r tr
f ll e s commumca 1 on se mgs are as
0
ow s:
Baud rate: g,6oo bps
Data length: 8 bits
Parity bit: None
Stop bit:
1
bit
Flow control: None
Communicat ion procedure
Send the control commands from the PC via the RS-232C.
The TV operates according to the received command and sends a
response message t o the PC.
Do not send multiple commands at the same time.
Wait until the PC receives the OK response before sending the next
command.
ENG 8-2
ENGLISH
I
FRAN<;AIS
I
ESPANOL