How To Use; Before Use; Clean The Refrigerator; Connect The Power Supply - LG LSXS26336 Series Owner's Manual

20

HOW TO USE

HOW TO USE

Before Use

Clean the refrigerator.

Clean your refrigerator thoroughly and wipe o all dust that accumulated during
shipping.
Do not scratch the refrigerator with a sharp object or use a detergent that
contains alcohol, a ammable liquid or an abrasive when removing any tape
or adhesive from the refrigerator.
Do not peel o the model or serial number label or the technical information
on the rear surface of the refrigerator.
Remove adhesive residue by wiping it o with your thumb or dish detergent.

Connect the power supply.

Check if the power supply is connected before use.
Read the "Turning On The Power" section.
Turn off the icemaker if the refrigerator is not yet connected to
the water supply.
Plug the power plug of the refrigerator into the grounded electric outlet and then
OFF
turn o the automatic icemaker.
* This is applicable only to certain models.
Running the automatic icemaker before connecting it to the water supply
may cause the refrigerator to malfunction.
Wait for the refrigerator to cool.
Allow your refrigerator to run for at least two to three hours before putting food
in it. Check the ow of cold air in the freezer compartment to ensure proper
cooling.
Putting food in the refrigerator before it has cooled could cause the food to
spoil, or a bad odor could linger inside the refrigerator.
The refrigerator makes a loud noise after initial operation.
This is normal. The volume will decrease as the temperature lowers.
Open refrigerator and freezer doors to ventilate the interior.
The inside of the refrigerator may smell like plastic at rst. Remove any adhesive
tape from inside the refrigerator and open the refrigerator and freezer doors for
ventilation.
CAUTION
NOTE
CAUTION
CAUTION