Oki C821 User Manual page 57

ITEM
Network SNMP
Setup
(cont.)
Network
Scale
Hub Link
Setting
Factory
Defaults?
Print Setup Personality
Copies
Duplex
Binding
Media Check
Resolution
Toner Save
Mode
SETTINGS EXPLANATION
Enable Sets Enable/Disable of SNMP.
Disable Enable: SNMP is available.
Disable: SNMP is not available.
TCP/IP or NetWare should be enabled.
Normal When Normal is selected, the network can work
effectively even when it is connected to a HUB that has a
Small
spanning tree feature. However, printer start up time gets
longer when computers are connected with two or three
small LANs.
When Small is selected, computers can cover from two or
three small LANs to a large LAN, but may not work
effectively when the network is connected to a HUB with a
spanning tree feature.
Auto Negotiate Sets a method to link to a HUB. When Auto is set, a
connection method to a HUB is selected automatically.
100Base-TX Full
100Base-TX Half
10Base-T Full
10Base-T Half
Execute Specifies whether to initialize the network factory default
settings for the Network.
Auto Selects a printer language.
PostScript
PCL
IBM PPR
EPSON FX
1- 999 Selects the default number of copies.
On/Off Specifies Duplex print (option) if a Duplex unit is installed
and enabled
Long Edge Specifies Binding in duplex printing (if a Duplex unit is
installed and enabled)
Short Edge
Enable Sets whether the printer checks the matching of printed
data size and that of the tray. Only standard sizes are
Disable
checked.
600dpi Sets default resolution.
600x1200dpi
600dpi multi-
level.
On/Off This function works effectively only if the data input is
color RGB data. This setting is valid in PS and PCL, but
does not take effect in the following cases.
(1) PS: If Color Matching is set OFF.
(2) PS: If any setting other than ASIC Color Matching is
set.
(3) PS: CMYK data when Ink Simulation Mode is used
(valid in any other cases except Case (1) and Case (2)
above as long as data is RGB).
(4) PCL binary data (Color/Monochrome).
Menu functions - C821 and C830 > 57