Table of Contents
Advertisement
Location
Comments
Printer Trap
By selecting the button, the following dialogue box is displayed:
Setup . . .
In the dialogue box, the following items can be configured:
Printer Trap
Community Name
TCP#1—5
Detail . . .
This community name is assigned to outgoing
printer status traps such as off-line, paper out,
etc.
Set the IP address to which a Trap packet will be
sent. You can set up to five IP addresses.
By selecting the button, the following dialogue
box is displayed:
In the dialogue box, the following items can be
configured:
Trap Enable
Printer Reboot
Receive Illegal
On-line
Network Configuration 20
Set sending a Trap
packet, enabled or
disabled, for each
destination.
Set sending a Trap
packet, enabled or
disabled, when the
printer is rebooted.
Set sending a Trap
packet, enabled or
disabled, when the
printer receives an
illegal Trap packet.
Set sending a Trap,
enabled or disabled,
when the printer turns
to ON-LINE.
Advertisement
Table of Contents
