How To Operate Your Dishwasher - GE Spacemaker GSM603 Use And Care Manual

Hide thumbs Also See for Spacemaker GSM603:
Table of Contents

Advertisement

How to operate your dishwasher
Cycle Indicator Dial
(Turn to start)
Vapor Vent
Door Latch (Unlocked)
\
EIElsRaasas
STEP 1. Load your dishwasher
with dishes, silverware, pots,
pans, bowls, etc. according to
instructions on pages 8 and 9.
STEP 2. Add detergent to the
detergent dispenser. Make sure the
Cycle Indicator Dial is at OFF
position before adding detergent.
(See pages 6 and 7.)
Use rinse aid agent to help prevent
spotting. Occasionally check to
make sure the rinse agent container
is at least half full. (See page 6,)
STEP 3. Select Drying Option.
HEATED
ENERGY
DRYING
SAVER
Inn
HEATED DRYING. Turns the
drying heater on for fast drying.
ENERGY SAVER(no-heat drying).
Turns the drying heater off to save
energy. Dishes will dry naturally
over a longer period such as
overnight.
If you need your dishes sooner,
open the dishwasher door after the
cycle is complete to reduce the
natural drying time.
Use of this option reduces the
electrical energy used by this
model approximately 7 % for the
NORMAL WASHcycle.
STEP 4. Select the cycle and start
the dishwasher. (See Cycle Selection
Hints at right.)
If your dishwasher drains into a
food waste disposer, operate the
disposer until it is empty before
starting the dishwasher.
. For POTSCRUBBER and
NORMAL WASH cycles:
POT-
NORMAL
SCRUBBER
WASH
IEIEI
a. Push selected cycle button.
b. Latch the door.
oFF@@oN
LIGHT
a
WASH
DRYING
RINSE
ONLY
w
'&:
ORYING
I
c. Slowly turn Cycle Indicator Dial
to ON position to start the cycle.
There is a time delay between
start-up and water fill so you will
not hear any wash action right
away.
To obtain the benefits of a complete
cycle, be careful that you do not
turn the dial any further than
necessary to start the dishwasher.
For LIGHT WMH cycle:
a. Be sure door is unlatched.
b. Push
NORMAL
WASH
button.
DRYING
Orrg@ofu
LIGHT
@
WASH
c. Slowly turn Cycle Indicator
Dial to LIGHT WASH position.
d. Latch door to start the cycle.
For RINSE ONLY cycle:
a. Be sure door is unlatched.
b. Select ENERGY SAVERdrying
option.
OFFS-ON
LIGHT
@
WASH
DRYING
,
RINSE
ONLY
U.X '&~:;
ORYING
c. Slowly turn Cycle Indicator
Dial to RINSE ONLY position.
d. Latch the door to start the cycle.
4
,.
..

Advertisement

Table of Contents
loading

Table of Contents