Circuit Breaker; Ac Power Switch - Emotiva XPA GEN3 User Manual

XPA Gen3

4. Circuit Breaker

The XPA Gen3 is protected by a heavy duty user-resettable Circuit Breaker. If a fault occurs, the
button on the Circuit Breaker will pop out. When the Circuit Breaker button is out, the XPA Gen3
will not operate, and none of the Status LEDs will be lit. To reset the Circuit Breaker, press the
button firmly in.
When the circuit breaker pops, the button will pop out and extend noticeably from the rear
panel. If this happens, try resetting the Circuit Breaker by pressing the button firmly in. If
the Circuit Breaker pops a second time, please contact Emotiva, or your nearest authorized
Emotiva service representative.
5. IEC Power Cord Receptacle
The XPA Gen3 can be powered by any receptacle that provides between 100 VAC and 250 VAC
at 50/60 Hz. This receptable accepts a standard removable IEC AC power cable (a high-quality
commercial power cable is included).
Note: The XPA Gen3 will provide excellent performance and exceptional sound quality with any
line voltage between 100 VAC and 250 VAC; however, for the absolute ultimate in performance,
a 230 VAC line is recommended.

6. AC Power Switch

Switches the main AC power to the XPA Gen3 On and Off. When this switch is Off, no controls
operate (the XPA Gen3 cannot be turned On from the front panel or by a trigger signal).
7. Covers
Blank metal cover plates cover unoccupied expansion slots in the XPA Gen3 chassis.
Page 9