Rc3 Remote Control - Nuvo T2 Installation Manual

NV-T2RC3 Remote Control
1. Power: The power button turns the selected tuner on and off.
2. Scroll Buttons: These buttons are the equivalent of turning the front panel Select knob. The top button is the equivalent of
turning the knob clockwise, and the bottom button is the equivalent of counterclockwise.
3. Enter: This button is the equivalent of pushing the Select knob on the front panel (see Front Panel #7).
4. Seek Up and Down: The seek buttons will tune to the next available station with the required signal strength for AM and FM
use. The signal threshold can be adjusted higher or lower using the T2 Configurator software (see pg. 25), or through the
advanced menu options on the front panel (see pg. 14).
5. Tune Up and Down: The tune function steps through each station frequency regardless of the frequency signal strength.
6. Category Up and Down: The category buttons step through each of the defined genre categories. Categories must be defined
in the advanced settings of the T2 Configurator software for AM/FM use (see pg. 26).
7. Pre/Dir: The T2 allows up to 10 preset stations in each of up to 10 preset banks. This button scrolls through each of the
defined banks and then to direct tuning. In direct tuning, you can use the numeric buttons to access a specific station
frequency or XM channel number. Presets are selected by a single push of numeric button 0-9.
8. Tuner A & B LED: This LED glows red when Tuner A is selected and green when Tuner B is selected. This LED glows only
momentarily when a button is pushed.
9. Tuner Selector: This button toggles between Tuner A and Tuner B operation.
10. Scan: The scan button tunes up to the next station with a signal strength above the programmed threshold for AM and FM or
to the next XM channel and waits 5 seconds before automatically tuning to the next station. This uses the same signal level as
the seek function.
11. Numeric Buttons: These buttons (0-9) are used to access a specific station frequency or choose a pre-defined station preset.
12. ENT: This button duplicates the enter function of the Enter button #3.
13. Source Buttons: These four buttons select each of the four available audio sources within the T2.
PWR
1
HOLD
ALL OFF
2
3
ENTER
4
SEEK
5
TUNE
6
CATEGORY
SCAN
2
1
4 5
7 8
7
0
PRE
DIR
FM
WX
T2 Tuner
REMOTE CONTROL
Page 8
8
A/B
9
TUNER
10
3
6
11
9
12
ENT
AM
13
AUX