Rf Exposure Information; Ce Mark Warning; National Restrictions - TP-Link Archer D20 User Manual

The device operates in 5.15 ~ 5.25GHz / 5.745 ~ 5.85 GHz frequency range. It is restricted
in indoor environment only. This device meets all the other requirements specified in
Part 15E, Section 15.407 of the FCC Rules.

RF Exposure Information

This device meets the EU requirements (1999/519/EC) on the limitation of exposure of
the general public to electromagnetic fields by way of health protection.
The device complies with RF specifications when the device used at 20 cm form your
body.

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio
interference, in which case the user may be required to take adequate measures.

National Restrictions

This device is intended for home and office use in all EU countries (and other countries
following the EU directive 1999/5/EC) without any limitation except for the countries
mentioned below:
Country
Belarus Not implemented
Norway
Implemented
Implemented
Italy
Russian Federation
implementation
Restriction
This subsection does not apply for the geographical area within a
radius of 20 km from the centre of Ny-Ålesund on Svalbard
The public use is subject to general authorisation by the respective
service provider
1 SRD with FHSS modulation
1.1. Maximum 2.5 mW e.i.r.p.
1.2. Maximum 100 mW e.i.r.p. Permitted for use SRD for outdoor
applications without restriction on installation height only for purposes
of gathering telemetry information for automated monitoring
and resources accounting systems. Permitted to use SRD for other
purposes for outdoor applications only when the installation height is
not exceeding 10 m above the ground surface.
1.3.Maximum 100 mW e.i.r.p. Indoor applications
Limited
2 SRD with DSSS and other than FHSS wideband modulation
2.1. Maximum mean e.i.r.p. density is 2 mW/MHz. Maximum 100 mW
e.i.r.p.
2.2. Maximum mean e.i.r.p. density is 20 mW/MHz. Maximum 100
mW e.i.r.p. It is permitted to use SRD for outdoor applications only
for purposes of gathering telemetry information for automated
monitoring and resources accounting systems or security systems.
2.3. Maximum mean e.i.r.p. density is 10 mW/MHz. Maximum 100 mW
e.i.r.p. Indoor applications
Reason/remark
110