Honda TRX500FM Service Manual page 420

FRONT DRIVING MECHANISM
19·32
Place the driver. attachment and pilot on the lop of the
bearing and tape the driver to the compressor (1).
TOOLS :
[2] Oriver
[3] Attachment, 22 x 24 mm
[4] Pilot, 15 mm
07949-3710001
07146"()010800
07746"()040300
Place Ihe bearing and tool assembly into a freezer for al
leasl 30 minutes.
Heat the gear case to
ao°c
(176°F).
Remove Ihe bearing and tool assembly from the freezer
and drive Ihe bearing into Ihe gear case using the
special tools.
Only strike Ihe driver once. If you strike it
more than
once, the ring 15] may slip out of the groove. If this
happens. remove the ring and bearing, and Install a
new ring.
Make sure Ihe stopper ring is securely set in the groove
afthe gear case.