Additional Safety Rules - Makita 1912B Instruction Manual

VOLTAGE WARNING: Before connecting the tool t o a power source (receptacle,
outlet, etc.) be sure the voltage supplied is the same as that specified on the
nameplate of the tool. A power source with voltage greater than that specified
for the tool can result in SERIOUS INJURY t o the user
-
as well as damage to
the tool. If in doubt, DO NOT PLUG IN THE TOOL. Using a power source with
voltage less than the nameplate rating is harmful to the motor.
ADDITIONAL SAFETY RULES
1. Rags, cloth, cord, string and the like should never be left around the work
2.
Avoid cutting nails. Inspect for and remove all nails from the workpiece before
3. Handle the blades very carefully.
4. Be sure the blade installation bolts are securely tightened before operation.
5. Hold the tool firmly with both hands.
6. Keep hands away from rotating parts.
7. Before using the tool on an actual workpiece, let
it
run for a while. Watch
for vibration or wobbling that could indicate poor installation or a poorly
balanced blade.
8. Make sure the blade is not contacting the workpiece before the switch is
turned on.
9. Wait until the blade attains full speed before cutting.
area.
operation.
IO.
Keep at least
200
mm
(8")
away from the tool at all times.
1 1. Always switch off and wait for the blades t o come to a complete stop before
12. Never stick your finger into the
* t p
chute. Chute may jam when cutting damp
13. Do not leave the tool running. Operate the tool only when hand-held.
14. When leaving the planer, switch off and set
it
with the front base up on a
15. Always change both blades or covers on the drum, otherwise the resulting
any adjusting.
wood. Clean out chips with a stick.
wooden block, so that the blades do not contact anything.
imbalance will cause vibration and shorten tool life.
SAVE THESE INSTRUCTIONS.
4