Connecting The Switcher - Sony VPL-FE110U Operating Instructions Manual

Connecting the Switcher

Use the optional PC-3000 Signal Interface Switcher
for connecting various video equipment. The input can
be selected by pressing the SWITCHER/VIDEO
MEMORY/INDEX keys on the Remote Commander.
For selecting the input from the switcher, see page 15.
Notes
• When you select the input from the switcher, be sure
to set the SWITCHER/VIDEO MEMORY/INDEX
select switch to the SWITCHER position.
Rear
to INPUT A
SIC-10 connecting cable
(5BNC y 5BNC)
(not supplied)
Computer, etc.
INPUT C INPUT B INPUT A VIDEO
PC CARD
+
–
AUDIO OUT
REMOTE CONTROL S TRIG DEVICE INDEX KEYBOARD MOUSE
0
to PJ COM IN
to OUTPUT
PC-3000 switcher
• When connecting the switcher, use the wired Remote
Commander. If you use the wireless Remote
Commander, it activates the remote control detector
on only one unit of the equipment connected through
the PJ COM connector. For the other equipment, set
SIRCS RECEIVER in the SET SETTING menu to
OFF to deactivate the remote control detectors.
For details, see page 30.
• After all the connections are completed, attach the
terminator (supplied) to the PJ COM connector on
both the projector and switcher to which nothing is
connected.
Device index number: 01
INPUT
C
AC power cord (supplied)
to AC IN
RCC-5G/10G/30G
connecting cable
(not supplied)
to PJ COM OUT
Attach the
OUT PUT
RS-232C/422A terminator
SW NO
RS-232C
REMOTE
RS-422A RS-485 IN
(supplied with
RS-485 OUT
the PC-3000).
VCR, etc.
RS-232C
Set to
RS-
RS-232C or
422A
RS-422A.
to the wall outlet
Attach the
supplied
terminator.
:
Signal flow
33