Removal From Storage; Transporting The Vehicle - Polaris ACE 900 SP Owner's Manual

Cleaning and Storage

Removal from Storage

1. Check the battery electrolyte level and charge the battery if
necessary. Install it in the vehicle. Make sure the battery vent hose is
routed properly and that it's not pinched or restricted in any way.
2. Make sure spark plugs are tight.
3. Fill the fuel tank with fuel.
4. Check all the points listed in the Daily Pre-Ride Inspection section
on page 46. Tightness of the bolts, nuts and other fasteners should
be checked by an authorized POLARIS dealer or other qualified
service facility.
5. Lubricate at the intervals outlined in the Periodic Maintenance
Chart beginning on page 75.
WARNING! Engine exhaust contains poisonous carbon monoxide and can
cause loss of consciousness or death. Never run an engine in an enclosed area.

Transporting the Vehicle

Follow these procedures when transporting the vehicle.
1. Place the transmission in PARK. Stop the engine.
2. Slowly release the brake pedal and make sure the transmission is in
PARK before exiting the vehicle.
3. Remove the key to prevent loss during transporting.
4. Secure the fuel cap and seat. Ensure that the seat is attached
correctly and is not loose.
WARNING! Cargo and other loose vehicle parts may fly off while transporting
this vehicle. Secure or remove all cargo, and inspect the unit for loose parts prior
to transport.
5. Always tie the frame of the POLARIS vehicle to the transporting
unit securely with suitable straps or rope. Do not attach tie straps to
the front control arm bolt pockets.
MAINTENANCE
119