Poe+ Led; Uplink Ports Leds - Cisco Catalyst 3650 Hardware Installation Manual

Front Panel
Table 1-7
Color
Off
Green
Blinking green
Amber
Blinking amber

PoE+ LED

If the PoE mode is not selected on a switch with PoE+ ports, the PoE+ LED still shows detected PoE+
problems.
Table 1-8
Color
Off
Green
Blinking amber

Uplink Ports LEDs

The four uplink ports have four status LEDs. Each port LED is labeled according to its SFP and SFP+
module status.
For SFP ports, a G(x) labeling nomenclature is used, where G = 1 Gigabit and x = the port number. The
The G(x) label appears to the left of the uplink port LED.
For SFP+ ports, a TE(x) labeling nomenclature is used, where TE = 10 Gigabit and x = the port number.
The TE(x) label appears to the right of the uplink port LED.
QSFP+ ports are labelled 1, 2, 3, and so on.
An SFP+ module ports has two labels, G(x) and TE(x), because it supports both SFP and SFP+ modules.
The uplink port labeling layouts for the various switch models are:
•
•
•
•
Catalyst 3650 Switch Hardware Installation Guide
1-20
RPS LED
RPS Status
RPS is off or not properly connected.
RPS is connected and can provide backup power.
RPS is connected but is unavailable. It is providing power to another device
(redundancy has been allocated to other device).
The RPS is in standby mode or in a fault condition. See the RPS documentation.
The RPS is providing power to the switch.
PoE+ Mode LED
PoE+ Status
PoE mode is not selected. None of the 10/100/1000 ports have been denied power
or are in a fault condition.
PoE mode is selected, and the port LEDs show the PoE+ status.
PoE mode is not selected. At least one of the 10/100/1000 ports has been denied
power, or at least one of the 10/100/1000 ports has a PoE+ fault.
Four uplink port LEDs labeled G1, G2, G3, G4—This labeling represents four ports supporting SFP
modules.
Four uplink port LEDs labeled G1, G2, G3, G4 and two right side uplink ports LEDs also labeled
TE3 and TE4—This labeling represents two ports (left side) supporting SFP modules and two ports
(right side) supporting SFP and SFP+ modules.
Four uplink port LEDs labeled G1, G2, G3, G4 and TE1, TE2, TE3, TE4—This labeling represents
four slots supporting SFP and SFP+ modules.
Ports labelled 1 to 8—This labelling represents eight ports supporting SFP and SPF+ modules.
Chapter 1 Product Overview
OL-29734-01