Table of Contents
Advertisement
Problem
Voltage too low.
Circuit breaker trips.
Voltage too high.
Generator overheating. a) Generator is overloaded.
No output voltage.
Excessive gear box
noise.
TROUBLESHOOTING
Possible Causes
a) Engine speed too slow.
b) Generator is overloaded.
a) Defective load connected to generator.
b) Defective receptacle.
c) Generator overloaded.
d) Defective circuit breaker.
a) Engine speed too high.
b) Insufficient ventilation.
a) Defective load connected to generator.
b) Broken or loose wire.
c) Defective receptacle.
d) Defective stator.
e) Defective rotor.
f) Defective capacitor.
g) Defective circuit breaker.
h) Engine speed too slow.
I)
PTO not engaged.
j)
Gear box is malfunctioning.
a) Defective bearing.
b) Defective gear.
c) No or low gear oil.
d) PTO driveline is operating at an angle of
greater than 15°.
e) Unsynchronized PTO driveline.
Possible Remedies
a) Increase tractor RPMs.
b) Reduce the load. (See Load
Application section of this manual.)
a) Disconnect load.
b) Replace receptacle.
c) Reduce the load. (See Load
Application section of this manual.)
d) Contact Customer Service for the
nearest service center.
a) Contact Customer Service for the
nearest service center.
a) Reduce the load. (See Load
Application section of this manual.)
b) Make sure there is at least 3 feet of
clearance on all sides of generator.
a) Disconnect load.
b) Replace wire.
c) Replace receptacle.
d) Contact Customer Service for the
nearest service center.
e) Contact Customer Service for the
nearest service center.
f) Contact Customer Service for the
nearest service center.
g) Contact Customer Service for the
nearest service center.
h) Increase tractor RPMs.
I)
Engage PTO.
j)
Contact Customer Service for the
nearest service center.
a) Contact Customer Service for the
nearest service center.
b) Contact Customer Service for the
nearest service center.
c) Fill gear box to oil level sight.
d) Reposition the tractor or generator so
the angle is reduced to less than 15° both
vertically and horizontally.
e) Disassemble PTO driveline and
reassemble with CV joints synchronized.
9
Advertisement
Table of Contents
