DeWalt DW678E User Manual page 20

E N G L I S H
Check for misalignment and seizure of moving
parts, breakage of parts and any other conditions
that may affect its operation. Have damaged
guards or other defective parts repaired or
replaced as instructed. Do not use the tool if the
switch is defective. Have the switch replaced by
an authorized D WALT repair agent.
E
20 Have your tool repaired by an authorized
D WALT repair agent
E
This Power Tool is in accordance with the
relevant safety regulations. To avoid danger,
electric appliances must only be repaired by
qualified technicians.
Package contents
The package contains:
1 Planer
1 Parallel fence
1 Rabbeting depth stop
2 Wing bolts
1 Spanner
1 Dust extraction adapter
1 Dustbag (K-models only)
1 Metal case (K-models only)
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fig. A)
Your high performance Planer has been designed
for professional planing of wood.
1 ON/OFF-switch
2 Lock-off button
3 Right/Left shavings discharge cassette
4 Planing depth adjustment knob
5 Planing depth graduation
6 Threaded hole for parallel fence
7 Hole for stationary stand
8 Rabetting depth stop
9 Side guard
10 Motor cover
11 Drive belt cover
12 Parking shoe
en - 3
DW678E - Soft start feature
The soft start feature allows the cutting speed to
build up slowly, thus reducing the immediate torque
reaction transmitted to the belt drive and the
operator.
DW678E - Constant speed feature
The constant speed feature maintains the cutting
speed under load. This means less noise and a
constant cutting speed. Moreover the speed will not
increase dramatically when lifting the tool off the
workpiece.
DW678E - Electronic brake
his model is equipped with an electronic brake
which immediately stops the cutters upon releasing
the ON/OFF-switch.
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
E
accordance with EN 50144; therefore no
earth wire is required.
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualified electrician.
E
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see below). Brown is for Live (L) (2)
and Blue is for Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
15