Connecting To Computer - Sanyo PLC-SE10 Owner's Manual

CONNECTING PROJECTOR
Cables used for connection
• VGA Cable (HDB 15 pin)
• Control Cable for PS/2 Port
• Control Cable for Serial Port
Monitor Input
VGA Cable
MONITOR OUT
EXT. SP(8Ω)(STEREO)
Audio Input
Speaker Terminal
12

CONNECTING TO COMPUTER

(✽ = Cable or adapter is not supplied with this projector.)
✽ , or ADB Port ✽
IBM-compatible computer or Macintosh computer (VGA / SVGA / XGA / SXGA)
Audio Output Monitor Output
MAC Adapter ✽
Set slide switches
according to the
chart below.
✽
Audio
Cable
✽
(stereo)
VGA Cable
AUDIO IN COMPUTER
Audio Cable
(stereo) ✽
External Speaker
• USB Cable ✽
• MAC Adapter (When connecting to Macintosh computer)
• Audio Cables (Mini Plug (stereo) x 1)
Desktop type
USB port Serial port
Control Cable
for Serial Port ✽
USB
Cable
✽
COMPUTER IN USB
VIDEO
R – AUDIO IN – L Y – Pb / Cb – Pr / Cr
(MONO)
EXT.SP(8Ω) AUDIO IN S – VIDEO USB
(STEREO) COMPUTER
RESET
MONITOR OUT COMPUTER IN CONTROL PORT
NOTE :
When connecting the cable, the power
cords of both the projector and the external
equipment should be disconnected from
AC outlet.
peripheral equipment on before the
computer is switched on.
N MAC ADAPTER (Not supplied)
Set switches as shown in the table
below depending on RESOLU-
TION MODE that you want to use
before you turn on projector and
computer.
13" MODE (640 x 480)
16" MODE (832 x 624)
19" MODE (1024 x 768)
21" MODE (1152 x 870)
✽
Laptop type
PS/2 port ADB port
Control Cable Control Cable
for ADB Port ✽
for PS/2 Port
Terminal Terminal Terminal
Use one of these Control
Cables corresponding with
the terminal of your
computer.
CONTROL PORT
Terminals
of the Projector
Turn the projector and
ON
ON DIP
1 2 3 4 5 6
OFF
1 2 3 4 5 6
ON ON OFF OFF OFF OFF
OFF ON OFF ON OFF OFF
OFF ON ON OFF OFF OFF
ON ON ON ON OFF OFF
✽