Battery Charging - Bosch GBH 36 V-LI Compact Professional Original Instructions Manual

Assembly

Battery Charging

Use only the battery chargers listed on the
accessories page. Only these battery charg-
ers are matched to the lithium ion battery of
your power tool.
Note: The battery is supplied partially charged.
To ensure full capacity of the battery, complete-
ly charge the battery in the battery charger be-
fore using your power tool for the first time.
The lithium ion battery can be charged at any
time without reducing its service life. Interrupt-
ing the charging procedure does not damage the
battery.
The lithium ion battery is protected against
deep discharging by the "Electronic Cell Protec-
tion (ECP)". When the battery is empty, the ma-
chine is switched off by means of a protective
circuit: The inserted tool no longer rotates.
Do not continue to press the
WARNING
On/Off switch after the machine
has been automatically switched off. The bat-
tery can be damaged.
Removing the Battery
The battery 11 is equipped with two locking lev-
els that should prevent the battery from falling
out when pushing the battery unlocking button
12 unintentionally. As long as the battery is in-
serted in the power tool, it is held in position by
means of a spring.
To remove the battery 11:
– Push the battery against the base of the
power tool (1.) and at the same time press
the battery unlocking button 12 (2.).
– Pull the battery out of the power tool until a
red stripe becomes visible (3.).
– Press the battery unlocking button 12 again
and pull out the battery completely.
Bosch Power Tools
Battery Charge-control Indication
The three green LEDs of the battery charge-con-
trol indicator 14 indicate the charge condition of
the battery 11. For safety reasons, it is only pos-
sible to check the status of the charge condition
when the machine is at a standstill.
Push button 15 to indicate the charge condition
(also possible when the battery is removed).
The battery charge-control indicator automati-
cally goes out after approx. 5 seconds.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green
When no LED lights up after pushing button 15,
then the battery is defective and must be re-
placed.
During the charging procedure, the three green
LEDs light up one after the other and briefly go
out. The battery is fully charged when the three
green LEDs light up continuously. The three
LEDs go out again approx. 5 minutes after the
battery has been fully charged.
The battery is equipped with a NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C. A long
battery service life is achieved in this manner.
Auxiliary Handle
Operate your machine only with the auxiliary
handle 16.
Rotating the Auxiliary Handle (see figure A)
The auxiliary handle 16 can be set to any position
for a secure and low-fatigue working posture.
Turn the wing bolt for adjustment of the auxilia-
ry handle 10 in anticlockwise direction and set
the auxiliary handle 16 to the required position.
Then tighten the wing bolt 10 again in clockwise
direction.
Adjusting the Drilling Depth (see figure B)
The required drilling depth X can be set with the
depth stop 1.
Press the button for the depth stop adjustment
9 and insert the depth stop into the auxiliary
handle 16.
English | 21
Capacity
≥2/3
≥1/3
<1/3
Reserve
1 619 929 797 | (3.12.07)