Adjustment Instruction - LG 42LG6000 Service Manual

1. Application Range
This spec. sheet is applied to all of the LD89F chassis
manufactured at LG TV Plant all over the world.
2. Specification
2.1 Because this is not a hot chassis, it is not necessary to
use an isolation transformer. However, the use of
isolation transformer will help protect test instrument.
2.2 Adjustment must be done in the correct order.
2.3 The adjustment must be performed in the circumstance of
25±5°C of temperature and 65±10% of relative humidity if
there is no specific designation.
2.4 The input voltage of the receiver must keep 100~240V,
50/60Hz.
2.5 The receiver must be operated for about 15 minutes prior
to the adjustment.
- After RGB Full White in HEAT-RUN Mode, the receiver
must be operated prior to the adjustment.
- Enter into HEAT-RUN MODE
(1) Press the "POWER ON" KEY on Adjustment R/C.
(2) Press the "ADJ KEY" on Adjustment R/C.
(3) Select "3. Test Pattern" by using D/E(CH +/-) and
press ENTER(V)
(4) Select "White" by using F/G(VOL +/-) and press
ENTER(V)
• Set is activated HEAT run without signal generator in
this mode.
• Single color pattern ( RED / BLUE / GREEN ) of HEAT
RUN MODE uses to check panel.
• Caution : If you turn on a still pattern more than 20
minutes (Especially digital pattern, cross hatch
pattern),an after image may be occur in the black level
part of the screen.
Copyright 2008 LG Electronics. Inc. All right reserved.
C
Only for training and service purposes
Downloaded From TV-Manual.com Manuals

ADJUSTMENT INSTRUCTION

- 13 -
3. PCB assembly adjustment method
=> Caution: Using 'power on' button of the Adjustment R/C ,
power on TV.
• ADC Calibration Protocol (RS232)
NO Item CMD 1 CMD 2 Data 0
Enter Adjust 'Mode In' A
Adjust MODE
ADC adjust ADC Adjust A
Adjust 'Mode Out' A
Adjustment A
Confirmation
- Baud rate : 115200 bps
- RS232 Host : PC
- echo : none
4. ADC adjustment
RF input
NO SIGNAL or White noise
• Adjustment can be done using only internal ADC, so input
signal is not necessary.
• Required equipment : Adjustment R/C.
1) Press ADJ key on adjustment R/C.
2) Select "1. ADC calibration" by using D/E(CH +/-) and
press ENTER(V)
3) Select "Start" by using F /G (VOL +/-) and press
ENTER(V)
4) ADC adjustment is executed automatically
D 0 0 When transfer the 'Mode In'
Carry the command.
D 1 0 Automatically adjustment
(The use of a internal pattern)
D 9 0
D 9 9 To check ADC Adjustment
on Assembly line.
AV / Component / RGB input
NO SIGNAL
LGE Internal Use Only