Table of Contents
Advertisement
1. Application Object
This instruction is for the application to the LCD TV/Monitor,
ML-024F.
2. Notes
(1) This LCD TV has power within set. Connect the power
correctly, then start the adjustment.
(2) The adjustment must be performed under the correct
sequence.
(3) The adjustment must be performed in the circumstance of
25±5°C of temperature and 65±10% of relative humidity if
there is no specific designation.
(4) The input voltage of the receiver must keep 100~220V,
50/60Hz in adjusting.
(5) The set must be operated for 15 minutes preliminary
before adjustment if there is no specific designation.
'Heat Run' must be performed with the full white signal or TV
noise signal in the internal part of the set.
The time for 'Heat Run' can be changed owing to production
plan.
Condition of Line Test : Standard color signal - 65±1dBuV
3. PC Mode Adjustment
3-1. Required Test Equipment
(1) Window Pattern which satisfied with VESA Spec. or
pattern which has White-Black signal simultaneously.
(2) Remote control for adjustment
3-2. Preparation for Adjustment
(1) Perform 'Heat Run' for more than 15 minutes in white
pattern.
(2) Connect the signal of pattern generator with LCD TV of PC
Input Jack.
(3) Confirm the XGA(1024x768) Window Pattern or
signal(White-Black) using the 801-GF/GD, VG819.
(4) Use the IN-START Key on R/C for adjustment to enter the
PC adjustment mode.
(5) Example of adjustment screen.
(6) Enter into the adjustment mode as <Fig. 1> and select the
cursor(red letters) to "RGBSE
R/C for adjustment.
(7) Press the Volume ( ) key on R/C for adjustment.
ADJUSTMENT INSTRUCTION
<Fig. 1>
" with the channel key on
(8) At this time the adjustment starts automatically changing
the number in order of RO --> GO --> BO --> RD --> GD --
> BD.
In adjustment, the lastest line, "60 Swver:2.5" is change to
"adjust". When adjustment is finished it's return to "60
Swver:2.5".
(9) Press the MENU or EXIT key to come out of the
adjustment mode.
4. COMPONENT Adjustment
(Only CMO MODULE)
4-1. Required Test Equipment
(1) Standard Color bar (75% Full Color bar) -> refer <fig.2>
(2) Remote control for adjustment
4-2. Preparation for Adjustment
(1) Operate Component Mode adjustment, after PC Mode
adjustment.
(2) Connect the signal of pattern generator with LCD TV of
Component Input Jack
(3) Confirm the Color bar (75% Full Color bar) signal using the
801-GF/GD, VG819.
(4) Use the IN-START Key on R/C for adjustment to enter the
Component adjustment mode.
(5) Example of adjustment screen.
(6) Enter into the adjustment mode as <Fig. 2> and select the
cursor(red letters) to "DTVADJT
on R/C for adjustment.
(7) Press the Volume ( ) key on R/C for adjustment.
(8) At this time the adjustment starts automatically changing
the color of Color bar.
Changing a color bar color, the adjustment srart. When
adustment is finished, the of previors adjustment and
changt the data's cost.
(9) Press the ENTER key. and then press EXIT key to come
out of the adjustment mode.
<Fig. 2>
" with the channel key
Advertisement
Table of Contents
