GE GFDR485 Owner's Manual And Installation Instructions page 6

Control settings.
Add Time
®1
Add Time
Press to add time to the Steam Dewrinkle,
Warm Up, Air Fluff or Time Dry cycles in !0
minute increments.
[
Temp I
Temp
You can change the temperature of your dry
cycle.
High
Medium
Low
Extra Low
No Heat
For regular to heavy cottons.
For synthetics, blends and items labeled Permanent Press.
For delicates, synthetics and items labeled Tumble Dry Low.
For lingerie and special-care fabrics.
This option may only be used with Air Fluff, in which items are tumbled without
heat.
!
Level
)
Level
The sensor continuously monitors the amount of
moisture in the load. When the moisture in your
clothes reaches your selected dry level, the dryer
will stop.
NOTE: Sensor dry Level only works with
Cottons, Normal, Active Wear, Delicates,
Speed Dry, Bulky, Towels/Sheets, Sanitize
and Steam Dewrinkle cycles.
Extra Dry Usefor heavy-duty fabrics or items that should be very dry, such as towels.
(on some
models)
More Dry Use for heavy or mixed type of fabrics.
Dry Usefor normal dryness level suitable for most loads. This isthe preferred cycle for energy
saving.
Less Dry Use for lighter fabric (ideal for ironing).
Damp Forleaving items partially damp.
Start/Pause
Ply Cycle
Hold 3 Seconds to Store
Start/Pause
Press to start a dry cycle. If the dryer is running,
press it once and it will pause the dryer. Press it
again to resume the dry cycle.
My Cycle
Set up your favorite combination of settings
and save them here for one touch recall. These
custom settings can be set while a cycle is in
progress.
To store a Ply Cycle combination of settings:
!. Select your drying cycle.
2. Change Temp and Level settings to fit your
needs.
3. Select any drying options you want.
4. Press and hold the My Cycle button for 3
seconds to store your selection. A beep will
sound and the button will light up.
To recall your stored Ply Cycle combination:
Press the PlY CYCLEbutton before drying a
load.
To change your stored Ply Cycle combination:
Repeat steps !-/4.