Switching Off The Appliance; Interrupting The Programme - Bosch SBV69M00GB Instruction Manual

en Operating the appliance
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button `
until : ... is indicated on the digital
display.
4. Release both buttons.
The LED for button # flashes
and the digital display h displays
the factory setting :
5. Keep pressing programme
button # until the value : ... is
indicated on the numerical display
h.
To change the setting:
1. Press programme button 3.
Each time the button is pressed,
the set value increases by one level;
when the value of :
reached, the display jumps back
to : .
2. Press START button `.
The set value is saved.
3. Close the door.

Switching off the appliance

Short time after the end of the
programme:
1. Open the door.
2. Switch off ON/OFF switch (.
3. Turn off the tap (not applicable if
Aqua-Stop fitted).
4. Remove the utensils when they have
cooled down.
24
.
has been
About the Eco drying function:
When Eco drying is activated in the
Eco 50° programme, the door opens
automatically when the programme
ends. This ensures the best possible
drying result. Low amounts of steam
may occur. If you install the appliance
under a worktop, fit the supplied steam
lock * (follow the procedures in the
installation instructions). The steam lock
protects sensitive fitted furniture and
worktops from damage by water vapour.
Before opening the appliance, leave it
to cool down for a while in the
remaining programmes when the
programme ends.
* depending on model

Interrupting the programme

1. Open the door.
2. Switch off ON/OFF switch (.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave
the door ajar for several minutes and
then close. Otherwise, expansion
(pressure) may cause the appliance
door to spring open or water to run
out of the appliance.
3. To continue the programme, switch
on the ON/OFF switch ( again.
4. Close the door.