Battery Power - Telefunken TF-1503U Instruction Manual

Utilization of the product
If you want to dispose of this product, do not
mix it with general household waste. There is a
separate collection system for used electronic
products in accordance with legislation that
requires proper treatment, recovery and
recycling.
Please contact your local authorities for
the correct method of disposal. By doing so,
you will ensure that your disposed product
undergoes the necessary treatment, recovery
and recycling and thus prevent potential
negative effects on the environment and
human health.
Important safeguards
• The instruction manual contains important
operating and maintenance instructions. For
your safety, it is necessary to refer to the
manual. Keep the manual at hand for future
use.
• Do not hit or drop the unit.
• Do not expose the unit to vibration, direct
sunlight, too high or low temperature or humidity.
• Do not disassemble the unit yourself.
Refer servicing to qualified service personnel.
• When the battery is exhausted, it should
be removed from the set to prevent leakage.
Power supply

Battery power

• Open the battery compartment cover.
Insert 4 x AA (1.5 V) batteries (not included).
Please observe correct battery polarities
or the unit will not work. Close the battery
compartment cover.
• When the batteries are exhausted, they
should be replaced.
• Do not use new and old batteries together.
Instruction manual
Additional power
• There are 2 extra AG13 batteries (1.5 V)
included with the receiver to be inserted to the
terminal inside the battery compartment. This
is additional power intended for saving the
clock and alarm settings. Without the additional
power the time and alarm settings will not be
stored if the power is switched off.
• When the batteries are exhausted they
should be replaced. New batteries should be
aquired by user. Replace the batteries only
with batteries of the same type.
ATTENTION: AG13 batteries are
consumables not covered by warranty, and
their failure (discharge) is not a ground for
addressing to service and repair centers
AC adaptor power
• Plug the supplied AC/DC power adaptor
into the power input on the back of the unit.
Connect the power cord to a household mains
outlet. Make sure the voltage is compatible.
• Always remember to disconnect the
power cord from the main supply before
disconnecting it from the unit.
• Disconnect the power cord from the mains
when not in use.
General operations
Clock
• In clock mode press and hold SET button
to enable time setting mode. Press repeatedly
SET button to go to setting of parameters in
following sequence: 12/24 hours => hours =>
minutes => year => month => date => exit.
The selected parameter will blink meaning
readiness for adjustment.
• Press SKIP UP button to adjust the
parameter up. Press SKIP DN to adjust the
parameter down.
• Day of week will be set automatically.
3