Assembly - NordicTrack NTTL25900 User Manual

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own slotted screwdriver
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
1. Slide the treadmill out of the box. Insert the three Cage
Nuts (28) into the three indicated holes in the treadmill.
To insert each Cage Nut (28), first hook one side of the
Cage Nut into the hole and then use a flat-bladed screw-
driver to press the other side into the hole, as shown.
2. With the help of a second person, carefully raise both
Uprights (83) to a vertical position. Make sure that the
Lock Knob Sleeve (87) is in the left Upright.
Next, make sure that the Lock Pin Collar (89) and the
Spring (88) are on the Lock Pin (91). (Note: If there are
two Lock Pin Collars, place one on each side of the
Spring.) Insert the Lock Pin into the Lock Knob Sleeve
(87) and the Left Upright (83).
Press the Lock Knob Spacer (86) onto the left Upright
(83). Tighten the Lock Knob (85) onto the Lock Pin (91).
.
1
28
2
85
6
28
83
86
88
91
87
89