NordicTrack NTL12905.2 User Manual page 8

5. Remove the knob from the pin. Make sure that the collar
and the spring are on the pin.
Press the Latch Insert (77) into the right side of the left
Upright (85), and press the Knob Insert (92) into the left
side of the left Upright. Use a rubber mallet, if necessary.
Next, insert the pin into the Latch Insert, and tighten the
knob back onto the pin.
6. Place the treadmill in the storage position (see HOW TO
FOLD AND MOVE THE TREADMILL on page 27).
Hold the cylinder end of the Shock (114) near the
bracket in the center of the crossbar on the Frame (55).
See the two small inset drawings. Using your fingernail
or the end of a screwdriver, press on the end of the
Shock Clip (108) to loosen it from the Shock (114). Next,
rotate the Shock Clip and pull it out of the Shock. Be
careful to avoid losing the Shock Clip.
Orient the Shock (114) so it is in the position shown.
Press the end of the Shock onto the ball on the bracket.
See drawing 6a. Insert the Shock Clip (108) into the two
indicated small holes in the end of the Shock (114).
Then, rotate the Shock Clip until it clips onto the Shock.
Note: Extra Shock Pins are included.
5
Knob
92
85
6
108
6a
Hole
108
8
77
Spring
Collar
Pin
108
114
Cylinder
Bracket
108
55
114
Bracket
Hole