Assembly - NordicTrack NTEX03990 User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included allen wrench
and two adjustable wrenches
Use the drawings below to identify the small parts used in assembly. The number in parenthesis below each part
refers to the key number of the part, from the PART LIST on page 10. The second number refers to the quantity
needed for assembly. Note: Some parts may have been pre-attached. If a part is not found in the parts
bag, check to see if it has been pre-attached.
M10 Lock Washer (11)–12
1. Attach the Rear Stabilizer (8) to the Frame (1) with
four M10 x 25mm Button Screws (12) and four M10
Lock Washers (11).
2. Remove the three M8 Nylon Locknuts (74) and M8
Split Washers (60) from the bottom of the Seat (7).
Attach the Seat (7) to the Seat Post (6) and the
Cover Flange (71) with the three M8 Nylon Locknuts
(74) and M8 Split Washers (60).
.
M10 x 25mm Button Screw (12)–8
4
as well as a phillips screwdriver
M9.5 x 25mm Button Screw (51)–4
1
11
11
12
2
6
71
60
74
1
8
7
60
74