Handset Settings; Changing The Display Language - Gigaset C34 Manual

Handset settings

During the call, all keys are locked except
the end call key. The room monitor
function remains active after you end the
call. It must be activated again if the hand-
set has been switched off.
When the function is activated, incoming
calls are signalled on the handset without
a ring tone and only appear on the
display. The display and keys are not illu-
minated and advisory tones are also
turned off.
Caution!
– The connection to which the room monitor
is diverted must not be blocked by an acti-
vated answering machine.
– Ideally the handset should be positioned 1
to 2 metres away from the baby. The micro-
phone must be directed towards the baby.
– You should always check the operation
of the room monitor before use. For
example, test its sensitivity. Check the
connection if you are diverting the room
monitor to an outside number.
– The active room monitor function consider-
ably reduces the operating time of the
handset. Place the handset in the charging
cradle if necessary. This ensures that the
battery does not discharge.
Activating the room monitor and
entering the number to be called
¢
Additional Features
§Menu§
¢
Monitor Call Internal
s / ~
Depending on the base, select
internal handset or
several handsets are regis-
tered and you want all of them
to be called) and press
enter the handset's number
manually and press
The function is now activated. An internal
handset will be called.
Or:
¢
Additional Features
§Menu§
¢
Monitor Call External
~
Enter the number of an exter-
nal phone and press
12
¢
Room
(if
Call All
or
§OK§
.
§OK§
¢
Room
.
§OK§
The function is now activated. An exter-
nal number will be called.
Setting the sensitivity
¢
Additional Features
§Menu§
¢
Monitor Level
s
Choose between
and press
Deactivating the room monitor
Press the control key.
§Menu§
s
Select
Room Monitor off
press
§OK§
The function is deactivated.
Deactivating the room monitor
remotely
Important: The telephone must support
touch tone dialling.
¤
Take the call from the room monitor
and press keys 9 ;.
The room monitor function will deactivate
around 90 seconds after the call ends.
There will be no further room monitor
calls.
Handset settings
Your handset is preconfigured, but you
can change the settings to suit your indi-
vidual requirements.

Changing the display language

You can view the display texts in different
languages.
¢ ¢
Settings
§Menu§
The current language is indicated by ‰.
q
Select a language and
press
§OK§
a
Press and hold (idle status).
¢
Room
and
Low High
.
§OK§
and
.
¢
Handset Language
.