NordicTrack NTXC80181 User Manual page 10

9. Slide the resistance strap back onto the flywheel.
Note: If the resistance strap is frayed on both sides,
it may be necessary to replace it. See the back
cover of this manual for information on how to
order replacement parts.
GENERAL LUBRICATION
If the front and rear
Rollers (15) begin to
squeak, a drop of
light household oil
may occasionally be
needed on the
Roller Axles (70).
However, the drive
rollers located near
the flywheel are
internally lubricated
and should NOT
be oiled. Follow the
instructions below to apply the oil.
1. Place a cloth or a piece of plastic underneath the
ski exerciser to protect your floor.
2. Put a drop of light household oil on each side of
each roller, and then spin each roller.
STORAGE
Loosen the resistance completely and remove any
accessories before folding and storing your ski exer-
ciser. For long term storage of more than 30 days we
recommend the following:
1. Remove the batteries from the console.
2. Slide the resistance strap off the flywheel.
3. Lightly coat the groove of the flywheel with a light
Flywheel
Oil
Oil
4. Loosen the two adjustment knobs on the hip pad.
5. Move the hip pad slide so the tip is about seven
70
15
6. Support the upper body arm with one hand. Use
7. Hold the upright with one hand. Loosen and
Upon removal from storage, clean the flywheel with
rubbing alcohol. Slide the resistance strap back onto
the flywheel.
To move the ski exerciser, use the handlebar to pull it
back on its wheels and roll it to the desired location.
10
household oil to protect the metal from corrosion.
IMPORTANT: Never place oil on the resistance
strap. Only the flywheel should be oiled and
then cleaned before the resistance strap is reat-
tached. Do not place the resistance strap onto
the oiled flywheel.
inches below the top of the upright. Retighten both
the adjustment knobs and pivot the hip pad
upward.
the other hand to depress the two snap buttons on
either side of the arm. Lower the upper body arm
until it rests against the upright.
remove the upright knob from the upright. Lower
the upright until it rests on the base. The hip pad
should just touch the top of the skis.