Sub Brightness Setting - Panasonic TH-42PW5 Service Manual

TH-42PW5 / TH-42PWD5 / TH-37PW5 / TH-37PWD5

10.7. Sub brightness setting

INPUT
1 NTSC
Gray Scale
Pattern
Black 2 %
Black 0 %
2 PAL
Gray Scale
Pattern
Black 2 %
Black 0 %
SECAM
Gray Scale
Pattern
3 PC
Gray Scale
Pattern
Black 2 %
Black 0 %
RGB
Gray Scale
Pattern
DVI
Gray Scale
Pattern
Equipment Setting
Picture: PANEL W/B
Normal
Aspect:
16:9
Picture: PANEL W/B
Normal
Aspect:
16:9
Picture: PANEL W/B
Normal
Aspect:
16:9
Alignment menu
** Adjust at the dark room.
All cut off 1) Set white balance to Cool .
2) Adjust All cut off to start some pixels emission
at black 2% area and no emission at black 0% area.
3) Write down all cut off data.
4) Set white balance to Nornal .
5) Adjust All cut off to set same data of Cool mode.
6) Set white balance to warm .
7) Adjust All cut off to set same data of Cool mode.
** Adjust at the dark room.
All cut off 1) Set white balance to Cool .
2) Adjust All cut off to start some pixels emission
at black 2% area and no emission at black 0% area.
3) Write down all cut off data.
4) Set white balance to Nornal .
5) Adjust All cut off to set same data of Cool mode.
6) Set white balance to warm .
7) Adjust All cut off to set same data of Cool mode.
8) Change to SECAM signal.
9) Copy PAL All cut off data to SECAM mode.
** Adjust at the dark room.
All cut off 1) Set white balance to Cool .
2) Adjust All cut off to start some pixels emission
at black 2% area and no emission at black 0% area.
3) Write down all cut off data.
4) Set white balance to Nornal .
5) Adjust All cut off to set same data of Cool mode.
6) Set white balance to warm .
7) Adjust All cut off to set same data of Cool mode.
8) Change to RGB input signal.
9) Copy PC All cut off data to RGB mode.
10) Change to DVI input signal.
11) Copy PC All cut off data to DVI mode.
26
Procedure