Note:
OSD is the difference between UY/UZ model and Except UY/UZ model. / Picture:Normal (Except UY/UZ)
/Standard (UY/UZ model) / White balance (Except UY/UZ)/Color Temp (UY/UZ model)
10.2. NTSC panel white balance
10.3. PAL/SECAM panel white balance
10.4. PC/RGB panel white balance
10.5. HD/ 525i /525p panel white balance
10.6. 625i panel balance
10.7. Sub brightness setting
11. Troubleshooting guide
11.1. Self Check
11.1.1. Display Indication
1. Self-check is used to automatically check the bus line controlled
circuit of the Plasma display.
2. To get into the Self-check mode, press the volume down button on the
customer controls at the front of the set, at the same time pressing the
OFF-TIMER button on the remote control, and the screen will show :-
If the CCU ports have been checked and found to be incorrect
Or not located then " - - " will appear in place of " OK "
Note:
In case of disconnected of H/HY/HZ "IC3699 - -" is displayed.
17