Table of Contents
Advertisement
ASSEMBLY
Assembly requires two people. Place all parts of the elliptical crosstrainer in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the two
included allen wrenches, assembly requires a phillips screwdriver
wrench
, a rubber mallet
As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly.
The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on
page 22. The second number refers to the quantity used in assembly. Note: Some small parts may have been
pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled.
M8 Split
Washer (58)–2
M10 x 43mm Button Screw (97)–4
M10 x 56mm Button Screw (60)–4
1. Identify the Rear Stabilizer (94), which has two Leveling
Feet (99) threaded into it. Turn the Rear Stabilizer so
the Leveling Feet are closest to the rear of the Frame
(1) as shown. Attach the Rear Stabilizer to the Frame
with the four M10 x 56mm Button Screws (60) and four
M10 Split Washers (22).
M8 Washer (33)–2
M8 x 19mm Screw (30)–2
M10 x 85mm Bolt (25)–1
, and pliers
M10 Split
Washer (22)–8
M10 x 33mm Carriage Bolt (61)–2
1
22
5
, an adjustable
.
M10 Washer (63)–2
M10 Nylon Locknut (26)–5
60
60
22
1
94
99
Advertisement
Table of Contents
