NordicTrack NTEL11990 User Manual page 7

5. Identify the Left Pedal Arm (3), which has an ÒLÓ sticker
attached to it. Next, identify the Left Pedal (41), which
has the letter ÒLÓ molded onto the bottom.
Turn over the Left Pedal Arm (3) as shown. Insert the
three plastic posts on the Left Pedal (41) into the three
indicated holes in the Left Pedal Arm. Make sure that
the Left Pedal is turned as shown. Attach the Left
Pedal with three Pedal Screws (43).
Attach the Right Pedal (not shown) to the Right Pedal
Arm (not shown) in the same way.
6. Apply a small amount of grease to the axle on the left
Crank Arm (6).
Side a Plastic Pedal Spacer (85) and the Left Pedal
Arm (3) onto the axle on the left Crank Arm (6). Note: It
may be helpful to use a rubber mallet to tap these parts
on. Be careful not to confuse the Left Pedal Arm
with the Right Pedal Arm (not shown); look at the
position of the round tube to correctly identify the
Left Pedal Arm. Next, tap a 3/4Ó Axle Cap (61) onto
the axle.
Attach the Right Pedal Arm (not shown) in the same way.
7. Carefully pivot the Upright (2) to the position shown.
Secure the Upright by tightening the M10 x 24mm
Screw (90) with the M10 Flat Washer (44) into the
Upright and the Frame (1).
5
43
3
41
6
3
61
7
2
44
90
7
Open Side
Plastic Posts
Grease
6
85
Round
Tube
1