Related Manuals for Miele DA 1050-55
Summary of Contents for Miele DA 1050-55
- Page 1 Operating and installation instructions Rangehood To prevent the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time. en-AU, NZ M.-Nr. 09 712 770...
-
Page 2: Table Of Contents
Contents Warning and Safety instructions................ 3 Caring for the environment ................ 12 Description of the functions ................ 13 Guide to the appliance .................. 14 Operation...................... 16 Switching the fan on....................16 Switching the fan off ..................... 16 Switching the cooktop lighting on/off ..............16 Energy saving tips .................... -
Page 3: Warning And Safety Instructions
It must only be used to extract vapours and remove odours from cooking. Any other usage is at the owner's risk. Miele cannot be held liable for damage resulting from incorrect or improper use or operation. Where a recirculation rangehood is fitted above a gas cooktop, please ensure that there is an adequate supply of fresh air into the room in which it is installed. - Page 4 Warning and Safety instructions This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning its use by a person responsible for their safety, and are able to recognise the dangers of misuse.
-
Page 5: Technical Safety
Repairs and other work by unqualified persons could be dangerous. Installation, maintenance work and repairs to electrical appliances must only be carried out by a Miele approved service technician. A damaged appliance can be dangerous. Check it for visible signs of damage. - Page 6 The manufacturer's warranty will be invalidated if the appliance is not repaired by a Miele approved service technician. Faulty components must only be replaced by genuine Miele spare parts. The manufacturer can only guarantee the safety of the appliance when Miele replacement parts are used.
- Page 7 Warning and Safety instructions Using at the same time as other heating appliances that depend on the air from the room Warning - danger of toxic fumes! Great care should be taken when using the rangehood at the same time and in the same room or area of the house as another heating appliance which depends on the air in the room.
- Page 8 Warning and Safety instructions In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the rangehood and the heater are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
-
Page 9: Correct Use
Warning and Safety instructions Correct use Never use an open flame beneath the rangehood. To avoid the danger of fire, do not flambé or grill over an open flame. When switched on, the rangehood could draw flames into the filter. Fat deposits could ignite, presenting a fire hazard. -
Page 10: Correct Installation
Warning and Safety instructions Do not use the rangehood without the filters in place. This way you will avoid the risk of grease and dirt getting into the appliance and hindering its smooth operation. The rangehood can get very hot during cooking due to heat rising from the cooktop. - Page 11 Accessories Use only genuine original Miele spare parts. If spare parts or accessories from other manufacturers are used, the warranty will be invalidated, and Miele cannot accept liability.
-
Page 12: Caring For The Environment
Caring for the environment Disposal of the packing Disposing of your old material appliance The transport and protective packing Electrical and electronic appliances has been selected from materials which often contain materials which, if are environmentally friendly for handled or disposed of incorrectly, disposal, and can normally be recycled. -
Page 13: Description Of The Functions
Description of the functions Depending on the model of the Recirculation mode rangehood, the following options are (available as an optional extra with a available: conversion kit and charcoal filter: see "Technical Data") Air extraction mode The air is drawn in and cleaned first by The air is drawn in and cleaned by the the grease filters and then by a charcoal grease filters and directed outside. -
Page 14: Guide To The Appliance
Guide to the appliance... -
Page 15: Guide To The Appliance
Guide to the appliance a Controls b Cooktop lighting c NoSmell active charcoal filter (special accessory for recirculation mode) d Cover for the charcoal filter duct e Grease filters f Exhaust connection ( 150 mm, or 125 mm with reducing collar). g Non-return flap h Exhaust outlet i Recirculation grilles j Rotary control for the cooktop lighting (DA 1050-55, DA 1060) -
Page 16: Operation
Operation Switching the fan on For light to heavy cooking vapours and odours, select from power settings 1 to When frying or cooking food with strong vapours or a strong aroma, select the Intensive setting IS. Switch the fan on with the fan switch ... -
Page 17: Energy Saving Tips
Energy saving tips This rangehood operates very efficiently and economically. The following will help you to save even more energy when using it: – Ensure that there is sufficient ventilation in the kitchen when cooking. In extraction mode, if there is insufficient air flow the rangehood cannot operate efficiently and this causes increased operating noise... -
Page 18: Cleaning And Care
Please observe the following abrasive cleaning agent designed cleaning instructions. specifically for use on stainless steel, e.g. Original Miele ceramic and All external surfaces and controls can stainless steel cooktop cleaner. be cleaned using warm water with a To help prevent re-soiling, a... -
Page 19: Grease Filters
Cleaning and care Important for the controls Grease filters The re-usable metal grease filters in the Do not leave soiling on the controls appliance remove solid particles for any length of time. (grease, dust, etc.) from the kitchen Otherwise they may suffer vapours, preventing soiling of the discolouration or damage. - Page 20 Cleaning and care Cleaning the grease filters by hand After cleaning Clean the filters with a soft nylon After cleaning, leave the filters to dry brush in a mild solution of hot water on an absorbent surface before and a small amount of washing-up refitting them.
-
Page 21: Nosmell Active Charcoal Filter
This is designed to absorb cooking odours and is fitted in the canopy above the grease filters. Replacement charcoal filters can be obtained from Miele. See back cover for contact details, and "Technical data" for type and reference number. Fitting and replacing the charcoal filter ... -
Page 22: Changing A Lamp
Cleaning and care Remove the grease filters. Changing a lamp The halogen lamps become very hot during operation. They can cause burns even after being switched off for some time. Allow them to cool down for a few minutes before changing them. ... -
Page 23: After Sales Service And Warranty
After sales service and warranty In the event of a fault which you cannot remedy yourself, please contact Miele. The contact details for Miele are given at the back of these instructions. When contacting Miele, please quote the model and serial number of your appliance. -
Page 24: Installation
Installation Before installation Before installation, it is important to read the information given on the following pages as well as the "Warning and Safety instructions" at the beginning of this booklet. -
Page 25: Appliance Dimensions
150 mm, a spacer trim can be used to cover the building-in space left by the previous rangehood. The spacer trim can be ordered as an accessory in various widths: – Miele DAB 55 for DA 1050-55 – Miele DAB 60 for DA 1060, DA 1160 – Miele DAB 100 for DA 1100... -
Page 26: Safety Distance (S)
Installation Safety distance (S) The minimum distances between the highest part of a cooktop (including trivets, dials - depending on model) and the bottom of the rangehood are as follows, unless a greater distance is specified by the manufacturer of your cooking appliance. -
Page 27: Installation Recommendations
Installation Installation recommendations Protective foil – To achieve optimum vapour The housing components of stainless extraction, the rangehood must cover steel models have protective foil around the cooktop. It should be positioned them to protect them from transport centrally over the cooktop, not to the damage. - Page 28 Installation Check the position of the deflector. For operation in recirculation mode, cover the opening at the back of the rangehood with the sticker supplied with the NoSmell active charcoal filter (optional accessory). Extraction Recirculation Remove the deflector if necessary and turn it as appropriate for the operating mode required.
-
Page 29: Installation Under A Wall Unit
Installation Installation under a wall unit There are several holes on the top for installing the appliance under a wall unit. A drilling template is supplied for correct positioning. Use only the fixing points as shown on the drilling template and the screws supplied. -
Page 30: Wall Installation
Installation Fix the mounting brackets to the wall Wall installation using the plugs and screws supplied. You also have the option of fitting the rangehood to the wall using two The screws and plugs are designed mounting brackets. for use in solid walls only. For other types of wall construction, alternative fixings will be required. - Page 31 Installation Hang the rangehood on the brackets. Remove the lamps: – Loosen the halogen lamp's securing screw a little. – Slide the screw and the lamp downwards. – Then tighten the screw again. – Turn the lamp anti-clockwise and pull it out.
-
Page 32: For Air Extraction Mode
Installation For air extraction mode For 150 mm exhaust ducting, cut the exhaust socket to size with a sharp knife. For 125 mm exhaust ducting, the Secure the exhaust ducting to the exhaust socket is installed as it is. exhaust connection, e.g. with a hose clip (available as an optional accessory) on flexible ducting. -
Page 33: Mains Connection
Installation Mains connection Refer to the notes in “Electrical connection” and “Warning and Safety instructions” before connecting to the electricity supply. Plug the connection cable into an electrical socket. Functional check To do this, switch the fan on. –... -
Page 34: Electrical Connection
Electrical connection All electrical work should be undertaken by a suitably qualified and competent person in strict accordance with current national and local safety and building code regulations. Installation, repairs and other work by unqualified persons could be dangerous, for which the manufacturer cannot be held liable. -
Page 35: Connection For Air Extraction
Connection for air extraction – The exhaust ducting should not be Before installation, it is important kinked or compressed. to read the information given on the following pages as well as the – Ensure that all connections are "Appliance dimensions" and the strong and airtight. -
Page 36: Condensate Trap
Connection for air extraction Condensate trap Silencer To achieve even further reductions in noise levels, a special silencer (optional accessory) can be fitted in the ducting system. In addition to insulating the exhaust ducting, we recommend that a suitable Air extraction mode condensate trap is also installed to collect and evaporate any condensate which may occur. -
Page 37: Technical Data
Technical data Fan motor DA 1050-55, DA 1060 2 x 100 W DA 1160, DA 1100 2 x 120 W Cooktop lighting 2 x 50 W Total rated load DA 1050-55, DA 1060 300 W DA 1160, DA 1100 340 W... - Page 39 Miele Experience Centre South Melbourne: Freemans Bay, Auckland 1011 206-210 Coventry Street South Melbourne, VIC 3205 Miele Experience Centre Auckland: Miele Experience Centre and Office Sydney: 8 College Hill 3 Skyline Place Freemans Bay, Auckland 1011 Frenchs Forest, NSW 2086 Telephone:...
- Page 40 DA 1050-55 DA 1060 DA 1160 DA 1100 en-AU, NZ M.-Nr. 09 712 770 / 02...