Symbol PDT 8000 Series Quick Reference Manual page 34

P D T
w i t h
2 0 0 3
FCC RF Exposure Guidelines
Safety Information
The device complies with Internationally recognized standards covering Specific
Absorption Rate (SAR) related to human exposure to electromagnetic fields from
radio devices.
Reducing RF Influence - Use Properly
It is advisable to use the device only in the normal operating position and it is
recommended that no part of the human body be allowed to come too close to the
antenna during operation of the equipment.
Handheld Devices:
This device was tested for typical body-worn operation. The use of third-party belt-
clips, holsters, and similar accessories should not contain metallic components in its
assembly. The use of these accessories that do not satisfy these requirements may
not comply with FCC RF exposure compliance requirements, and should be avoided.
Laser Devices
Symbol devices using lasers comply with US 21CFR1040.10, and IEC825-
1:1993, EN60825-1:1994+A11:1996. The laser classification is marked on one of the
labels on the device.
Class 1 Laser devices are not considered to be hazardous when used for their
intended purpose. The following statement is required to comply with US and
international regulations:
Caution: Use of controls, adjustments or performance of procedures other than those
specified herein may result in hazardous laser light exposure.
Class 2 laser scanners use a low power, visible light diode. As with any very bright
light source, such as the sun, the user should avoid staring directly into the light
beam. Momentary exposure to a Class 2 laser is not known to be harmful.
8 0 0 0
W i n d o w s
f o r P o c k e t
32
S e r i e s
M o b i l e
P C s