Settings And Displays - Bosch TCA 53 Series Operating Instructions Manual

14
4 Dispensing button
With this button, a large cup
(approx. 125ml) of coffee can be dispensed.
● Press the button 4
to flash. The coffee is ground, brewed
and poured into the cup. Both LEDs light
up as soon as the process is finished.
The beverage size can be changed (see
section "Changing volume dispensed")
5 Steam generation button
h
The steam button
foaming or warming.
6 Steam dispensing dial
Hot water or steam can be dispensed by
g¡
turning the dial to
steam, the steam generation button
must be pressed first (see "Steam for foam­
ing milk").
7 LED display
The various LEDs indicate the following:
H
on T he water tank is empty and
needs to be filled
I
on T rays full:
Empty and replace them
I
flashing T rays missing:
Reinsert them
S
on R un the service programme
(see "Service programme")
S
flashing S ervice programme in
operation
J
on Turn dial to
J
flashing Turn dial to "O"
Robert Bosch Hausgeräte GmbH
F
Large coffee
F
. The LED will start
h
generates steam for
h
or . To dispense
h
g h
/
Settings and displays
Setting the water hardness
It is important that the water hardness be
set correctly, so that the appliance indicates
accurately when the descaling programme
should be run. The factory setting is a water
hardness of 4.
You can check the water hardness by
asking your local water supplier.
Degree Water hardness
German (°dH) French (°fH)
1 1­7
2 8­15
3 16­23
4 24­30
The appliance must be ready for use.
● Hold down the steam button
least 5 seconds. The number of LEDs 7a
H I S J
, b , c , d
the selected water hardness.
● Press the steam button
until the correct number of LEDs is lit; e.g.
for a hardness of 3, the LEDs 7a, b and c
H I S
( , , ) light up.
● Press the button 2
number of LEDs should light up briefly;
this indicates that the desired setting has
been saved successfully.
If a water filter (optional extra Order No.
461732) is used, the water hardness should
be set to 1.
Note: If no button is pressed within
90 s econds, the appliance switches to
stand­by mode without saving the new
settings. In this case, the previous water
hardness setting is retained.
The appliance must be rinsed when a filter
is first used and after changing the filter.
● Fill the tank with water up to the "0,5 l"
mark.
1­13
14­27
28­42
43­54
h
for at
that light up indicates
h
repeatedly
â
once. The selected
en