Mounting Instructions - D-Link DCS-4701E Quick Installation Manual

It is highly recommended that you configure and test your camera before mounting it.
Place the mounting sticker where you want to position the
camera. Make sure the camera base will be positioned so
that the cable channel is on the bottom.
Use a 6 mm drill bit to make the required holes
approximately 25 mm deep, then insert the wall anchors
into the holes.
If you are running the camera cables through the wall,
drill a hole in the center and pull the cables through the
hole.
Use the screws provided to mount the camera to the wall.
If you are running the camera cables out the side of
the camera, guide the camera cables through the cable
channel on the base.
Connect the power and Ethernet cables, or just the
Ethernet cable if you are using a PoE connection.
To adjust the camera's angle, turn the adjustment ring
counterclockwise to loosen it, then move the camera to
the desired position and angle. When you are finished,
turn the adjustment ring clockwise to tighten it.
If you need to waterproof your installation, please continue to the next page.
D-Link DCS-4701E Quick Installation Guide

Mounting Instructions

5 5