Cleaning And Maintenance - IKEA REALISTISK User Manual

ENGLISH

Cleaning and maintenance

CLEANING
WARNING!
- Never use steam cleaning equipment.
- Only clean the oven when it is cool to the
touch.
- Disconnect the appliance from the power
supply.
Oven exterior
IMPORTANT: do not use corrosive or
i
abrasive detergents. If any of these
products accidentally comes into contact with
the appliance, clean immediately with a
damp cloth.
• Clean the surfaces with a damp cloth. If it
is very dirty, add a few drops of washing
up detergent to the water. Finish off with a
dry cloth.
Oven interior
IMPORTANT: do not use abrasive
i
sponges or metallic scrapers or scourers.
Over time, these can ruin enamelled surfaces
and the oven door glass.
• After every use, allow the oven to cool
then clean it preferably while it is still
warm in order to remove built-up dirt and
stains caused by food residues (e.g. food
with a high sugar content).
• Use proprietary oven detergents and
follow the manufacturer's instructions to
the letter.
• Clean the door glass with a suitable
liquid detergent. The oven door can
be removed to facilitate cleaning (see
MAINTENANCE). Inner glass is smooth to
facilitate cleaning.
NOTE: during prolonged cooking of foods
with a high water content (e.g. pizza,
vegetables, etc.) condensation may form on
the inside of the door and around the seal.
When the oven is cold, dry the inside of the
door with a cloth or sponge.
Accessories
• Soak the accessories in water with
washing up detergent immediately after
use, handling them with oven gloves if still
hot.
• Food residues can be easily removed
using a brush or sponge.
Cleaning cycle of ovens with Pyrolytic
function:
WARNING!
• Do not touch the oven during the pyrolysis
cycle.
• Keep children away from the oven during
the pyrolysis cycle.
This function burns off spatters produced
inside the oven during cooking at a
temperature of approx. 500°C. At this high
temperature, the deposits turn into a light ash
which can be easily wiped away with a damp
cloth, when the oven is cool. Do not select the
pyrolysis function after every use, only when
the oven is very dirty or produces smoke or
fumes while preheating or cooking.
• If the oven is installed below a hob, make
sure that all burners or electric hotplates
are switched off during the self-cleaning
(pyrolysis) function.
• Remove all accessories before running the
pyrolysis function.
• Ensure large food particles and stains
are removed from the door glass before
starting the pyro cycle
• The appliance could be equipped with
pyrolysis function:
Standard cycle (PYRO): which is suitable
for cleaning a very dirty oven.
NOTE: during the pyrolysis function, the oven
door will not open; it will remain locked until
the temperature inside the oven has returned
to an acceptably safe level.
MAINTENANCE
14