Disassembly Instructions; Terminal With Locking Mechanism; Removing The Cabinet - Mitsubishi Electric MUZ-GE09NA Service Manual

11

DISASSEMBLY INSTRUCTIONS

<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are two types (refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
11-1. MUZ-GE09NA
MUZ-GE09NA2
MUZ-GE09NAH
MUZ-GE09NAH2 MUZ-GE12NAH2 MUZ-GE15NAH2
MUY-GE09NA
MUY-GE09NA2
OPERATING PROCEDURE

1. Removing the cabinet

(1) Remove the screw fixing the service panel.
(2) Pull down the service panel and remove it.
(3) Remove the screws fixing the conduit cover.
(4) Remove the conduit cover.
(5) Disconnect the power supply wire and indoor/outdoor
connecting wire.
(6) Remove the screws fixing the top panel.
(7) Remove the top panel.
(8) Remove the screws fixing the cabinet.
(9) Remove the cabinet.
(10) Remove the screws fixing the back panel.
(11) Remove the back panel.
Photo 2
Screw of the
cabinet
Screws of
the cabinet
OBH549F
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
MUZ-GE12NA MUZ-GE15NA
MUZ-GE12NA2 MUZ-GE15NA2
MUZ-GE12NAH MUZ-GE15NAH
MUY-GE12NA MUY-GE15NA
MUY-GE12NA2 MUY-GE15NA2
Screws of
the terminal block
support and the
back panel
Screw of the
service panel
Direction to
remove
Hooks
(2) The terminal with this connector has the
locking mechanism.
Hold the sleeve, and
pull out the terminal
slowly.
Connector
NOTE: Turn OFF power supply before disassembly.
Photo 1
Screws of the top panel
Screws of the cabinet
Photo 3
Conduit cover
64
PHOTOS
Screws of the top panel
Screws of the
conduit cover
Conduit plate
Back
panel
Screws
of the
back
panel
Service
panel