Remove The Memory Card; Charge The Battery; Antenna - Nokia SLIDE 3600 User Manual

Get started
1. Remove the back cover.
2. Insert the memory card card
into the memory card slot with
the contact surface facing
down, and press it until it locks
into place.
3. Replace the back cover.

Remove the memory card

Important: Do not remove the memory card in the
middle of an operation when the card is being accessed.
Removing the card in the middle of an operation may damage
the memory card as well as the device, and data stored on
the card may be corrupted.
You can remove or replace the memory card during phone
operation without switching the device off.
1. Ensure that no application is currently accessing the
memory card.
2. Remove the back cover.
3. Press the memory card slightly in to release the lock and
remove it.
4. Replace the back cover.

Charge the battery

1. Connect the charger to a wall socket.
14
2. Connect the lead from the charger to
the charger connector of your phone.
If the battery is completely discharged, it
may take a few minutes before the
charging indicator appears on the
display or before any calls can be made.
The charging time depends on the
charger used. Charging a BL-4S battery with the AC-4 charger
takes approximately 1 hour 30 minutes while the phone is in
the standby mode.

Antenna

Your device may have internal and external
antennas. As with any radio transmitting
device, avoid touching the antenna area
unnecessarily while the antenna is transmitting
or receiving. Contact with such an antenna
affects the communication quality and may
cause the device to operate at a higher power
level than otherwise needed and may reduce
the battery life.
The figure shows the antenna area marked in
grey.
© 2008 Nokia. All rights reserved.