Packet Data Settings - Nokia RM-320 User Manual

To enter the settings for the selected security mode,
select WLAN security
Security settings for WEP
WEP key in use
●
privacy (WEP) key number. You can create up to
four WEP keys. The same settings must be
entered on the WLAN access point device.
Authentication type
●
Shared for the authentication type between
your device and the WLAN access point device.
WEP key settings
●
(length of the key),
Hexadecimal), and
in the selected format).
Security settings for 802.1x and WPA/WPA2
WPA/WPA2 — Select the means of
●
authentication:
authentication protocol (EAP) plug-in, or
shared key to use a password. Complete the
appropriate settings:
EAP plug-in settings
●
your service provider instructs.
Pre-shared key
●
same password must be entered on the WLAN
access point device.
158
settings.
— Select the wired equivalent
— Select Open or
— Enter WEP encryption
WEP key format (ASCII
WEP key (the WEP key data
EAP to use an extensible
— Enter the settings as
— Enter a password. The
WPA2 only mode
●
are allowed to establish a connection in this
mode.
Advanced WLAN settings
Select Options
following:
IPv4 settings
●
device, the subnet IP address, the default
gateway, and the IP addresses of the primary and
secondary DNS servers. Contact your internet
service provider for these addresses.
or
IPv6 settings
●
Ad-hoc channel
●
channel number (1-11) manually, select
defined.
Proxy server address
●
the proxy server.
Proxy port number
●
Pre-
number.

Packet data settings

Press , and select
Connection
>
The packet data settings affect all access points
using a packet data connection.
— Only WPA2 enabled devices
Advanced settings and from the
>
— Enter the IP address of your
— Define the type of DNS address.
(only for Ad-hoc) — To enter a
— Enter the address for
— Enter the proxy port
Tools Settings
>
Packet data.
© 2008 Nokia. All rights reserved.
User
>