WEP key in use
— Select the wired equivalent
●
privacy (WEP) key number. You can create up to
four WEP keys. The same settings must be
entered on the WLAN access point device.
Authentication type
●
Shared
for the authentication type between
your device and the WLAN access point device.
WEP key settings
— Enter
●
(length of the key),
WEP key format (ASCII
Hexadecimal), and
WEP key
in the selected format).
Security settings for 802.1x and WPA/WPA2
WPA/WPA2
— Select the means of
●
authentication:
to use an extensible
EAP
authentication protocol (EAP) plug-in, or
shared key
to use a password. Complete the
appropriate settings:
EAP plug-in settings
●
your service provider instructs.
Pre-shared key
— Enter a password. The
●
same password must be entered on the WLAN
access point device.
WPA2 only mode
— Only WPA2 enabled devices
●
are allowed to establish a connection in this
mode.
Advanced WLAN settings
Select
Options
Advanced settings
>
following:
— Select
Open
or
WEP encryption
or
(the WEP key data
Pre-
— Enter the settings as
and from the
IPv4 settings
— Enter the IP address of your
●
device, the subnet IP address, the default
gateway, and the IP addresses of the primary and
secondary DNS servers. Contact your internet
service provider for these addresses.
IPv6 settings
— Define the type of DNS address.
●
Ad-hoc channel
(only for Ad-hoc) — To enter a
●
channel number (1-11) manually, select
defined.
Proxy server address
●
the proxy server.
Proxy port number
●
number.
Packet data settings
Press
, and select
Tools
Connection
Packet
data.
>
The packet data settings affect all access points
using a packet data connection.
Packet data connection
●
available
and you are in a network that supports
packet data, the device registers to the packet
data network. Starting an active packet data
connection (for example, to send and receive e-
mail) is quicker. If there is no packet data
coverage, the device periodically tries to
establish a packet data connection. If you select
When
needed, the device uses a packet data
User
— Enter the address for
— Enter the proxy port
Settings
>
>
— If you select
When
153