Stihl HSE 42 Instruction Manual page 25

When you use an extension cord, make
sure the plug and coupling are
waterproof or positioned in such a way
that they cannot come into contact with
water.
Only use cutting blades and accessories
that are explicitly approved for this
power tool by STIHL or are technically
identical. If you have any questions in
this respect, consult a servicing dealer.
Use only high quality parts and
accessories in order to avoid the risk of
accidents and damage to the unit.
STIHL recommends the use of original
STIHL replacement parts. They are
specifically designed to match the
product and meet your performance
requirements.
Never attempt to modify your power tool
in any way since this may increase the
risk of personal injury. STIHL excludes
all liability for personal injury and
damage to property caused while using
unauthorized attachments.
Do not use a pressure washer to clean
the unit. The solid jet of water may
damage parts of the unit.
Do not spray the power tool with water.
Clothing and Equipment
Wear proper protective clothing and
equipment.
Clothing must be sturdy
but allow complete free -
dom of movement. Wear
snug-fitting clothing, an
overall and jacket combi -
nation, do not wear a
work coat.
HSE 42, HSE 52
Avoid clothing that could get caught on
branches or brush or moving parts of the
machine. Do not wear a scarf, necktie or
jewelry. Tie up and confine long hair
(e.g. with a hair net, cap, hard hat, etc.).
Wear sturdy shoes with
non-slip soles.
Wear safety glasses.
Hearing protection is recommended,
e.g. earplugs or ear muffs.
Wear heavy-duty gloves.
STIHL offers a comprehensive range of
personal protective clothing and
equipment.
Transporting the Unit
Always switch off the power tool, unplug
it from the power supply and fit the blade
scabbard – even when you carry the unit
for short distances.
Carry the power tool by the handle –
cutting blades behind you.
In vehicles: Properly secure the power
tool to prevent turnover and damage.
Before starting work
Check that your power tool is properly
assembled and in good condition – refer
to appropriate chapters in the instruction
manual.
Voltage and frequency of the
–
machine (see rating plate) and the
voltage and frequency of your
power supply must be the same.
Check the connecting cord, plug
–
and extension cord for damage.
Never use damaged cords,
couplings and plugs or connecting
cords that do not comply with
regulations.
Receptacles of extension cords
–
must be splash-proof.
Position and mark the power supply
–
cord so that it cannot be damaged
or stepped on, tripped over or
endanger others.
Trigger switch lockout, trigger
–
switch and switch lever must move
freely and return to the idle position
when they are released.
English
23