Internal Links And Switches; Removing The Controller Programmer From Its Housing - Honeywell DCP 50 Product Manual

7

INTERNAL LINKS AND SWITCHES

7.1 REMOVING THE CONTROLLER PROGRAMMER FROM ITS
HOUSING
WARNING ! Before removing the instrument from its housing, ensure that
all power has been removed from the rear terminals. Disregard for
these instructions may cause injury or death!
To withdraw the instrument from its housing, simply grip the side edges of the front
panel (there is a finger grip on each edge) and pull the instrument forwards. This will
release the instrument from its rear connectors in the housing and will give access to
the instrument PCBs. Take note of the orientation of the instrument for subsequent
replacement into the housing.The positions of the PCBs in the instrument are shown in
Figure 7-1.
Figure 7-1 PCB Positions
7-1