Connect The Cables; Connect The Power Adapter; Factory Reset Button - D-Link DSL-504G Quick Installation Manual

Table of Contents

Place the Router in a safe and accessible location where you can easily view the LED indicators on the front of the device.

You are now ready to connect the Router. Follow these steps:

Connect the ADSL line - Use the twisted-pair ADSL cable (standard telephone cable) included with the Router to

connect it to the telephone wall socket. Plug one end of the cable into the ADSL port on the rear panel of the

Router and insert the other end into the wall socket. If you need to install a low pass filter, follow the instructions

of your ISP.

Connect the Router to your computer - Connect the Modem directly to a 10/100BASE-TX Ethernet adapter card

(NIC) or the factory installed Ethernet port on your PC or notebook computer. Use the Ethernet cable provided.

Connect the power adapter - Insert the AC Power Adapter cord into the power receptacle labeled 9V AC 1A

located on the back of the Router and plug the adapter into a suitable power source. You should see the Power

LED indicator light up and remain lit. After a few seconds, the Status LED indicator will start to blink green; this

indicates the Router is functioning. Look at the Ethernet Link/Act indicator and make sure it lights or blinks green;

this indicates the connection to your computer is OK. Use these LED indicators to monitor the Router for normal

function.

Factory reset button–The Router may be reset to the original factory default settings by depressing the reset

button three times while the device is powered on. Use a ballpoint or paperclip to push down the reset button.

Remember that this will wipe out any settings stored in flash memory including IP settings. The factory default IP

address of the Router is 10.1.1.1 and the subnet mask is 255.0.0.0.

Connect the Router to your computer

Connect the Cables

Connect the ADSL cable

Table of Contents