Exmark LAZER Z ADVANTAGE SERIES Operator's Manual page 28

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
4.1.8
4.1.9
4.1.10
4.1.12
Check for loose hardware.
Service Interval: Daily
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Visually inspect machine for any loose hardware or any other possible
problem. Tighten hardware or correct the problem before operating.
Service air cleaner.
Service Interval: 50 hrs.
More often under severe conditions.
See Engine manual for additional information.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Loosen wing nut and remove air cleaner compartment cover.
c) Remove foam pre-cleaner element and wash in warm water with detergent.
Rinse until all traces of detergent are eliminated and squeeze out excess
water (DO NOT wring). Air dry. Saturate with engine oil and squeeze out
excess oil.
d) Check paper element. DO NOT wash or use pressurized air to clean paper
element. Replace if dirty, bent or damaged.
e) Reinstall foam pre-cleaner to paper element, then reinstall paper element
and cover.
Change engine oil:
Service Interval: 100 hrs.
NOTE: Change oil and filter after first five (5) hrs. of operation.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Drain oil while engine is warm from operation.
c) The oil drain valve is located on the right hand side of engine.
Place pan under machine to catch oil. Fit hose in literature pack over oil
drain valve. Rotate valve 1/4 turn counterclockwise and gently pull outward
to open valve. Allow oil to drain, then close valve by pushing inward and
rotating 1/4 turn clockwise. Remove and retain the hose for future use.
d) Replace the oil filter every other oil change. Clean around oil filter and
unscrew filter to remove. Before reinstalling new filter, apply a thin coating of
oil on the surface of the rubber seal. Turn filter clockwise until rubber seal
contacts the filter adapter then tighten filter an additional 2/3 to 3/4 turn.
e) Clean around oil fill cap and remove cap. Fill to specified capacity and replace
cap. Use oil recommended in engine owner's manual. DO NOT overfill.
f) Start the engine and check for leaks.
Check hydraulic oil level:
Service Interval: 40 hr.
a) Stop engine and wait for all moving parts to stop.
b) Unhook seat latch and tilt seat up.
c) Clean area around hydraulic reservoir cap and remove cap. Oil level should
be to the top of the baffle inside the tank. If not, add oil. Use only Mobil 1
15W-50 synthetic motor oil. Replace hydraulic reservoir cap and tighten
until snug. Do not overtighten.
www.mymowerparts.com
- 23 -