Whirlpool werp4120pq0 Installation Instructions Manual page 4

Now start...
WARNING
Excessive Weight Hazard
Use two or more people to move and
install range.
Failure to do so can result in back or
other injury.
1.
Put on safety glasses and gloves.
Remove shipping materials, tape and
protective film from range. Keep
cardboard bottom and shipping base
under range. Remove oven racks and
parts package from inside oven.
cardboard
shipping base
2.
Do not remove the cardboard
shipping base at this time.
rear leveling leg
3.
Remove storage drawer. Use a 3/8"
drive ratchet to lower rear leveling legs
one-half turn. Use channel lock pliers to
lower front leveling legs one-half turn.
4
A child or adult can tip the range
and be killed.
Connect anti-tip bracket to rear
range foot.
Reconnect the anti-tip bracket, if
the range is moved.
Failure to follow these instructions
can result in death or serious
burns to children and adults.
Contact a qualified floor covering installer
for the best procedure for drilling
mounting holes through your type floor
covering.
4.
front
install the anti-tip bracket.
leveling leg
Anti-tip bracket must be anchored
securely to the sub-floor.
Depending on the thickness of your
flooring, longer screws may be necessary
to anchor the bracket to the sub-floor.
Longer screws are available from your
local hardware store.
Check that range is on cardboard
shipping base to protect floor covering.
WARNING
Tip Over Hazard
Use the anti-tip bracket template to
Operating position
Before moving range across floor, check
that range is still on cardboard shipping
base to protect floor covering.
5.
Move range close to cabinet
opening.
6.
Remove cardboard from under
range. Carefully move range into final
position.
anti-tip
bracket
range foot
7.
Making sure the anti-tip bracket is
installed:
• Look for the anti-tip bracket securely
attached to floor.
• Slide range back so rear range foot is
under anti-tip bracket.
8.
If installing the range in a mobile
home, you must secure the range to the
floor. Any method of securing the range
is adequate as long as it conforms to the
standards in the "Mobile home
installation" instruction section.
9.
Place rack in oven. Place level on
rack, first side to side; then front to back.
If range is not level, pull range forward
until rear leveling leg is removed from
the anti-tip bracket. Use 3/8" drive ratchet
and channel lock pliers to adjust leveling
legs up or down until range is level. Push
range back into position. Check that rear
leveling leg is engaged in anti-tip bracket.
NOTE: Oven must be level for satisfactory
baking conditions.
10.
Replace the storage drawer or
lower panel.