Assembly; Drive Shaft /Powerhead; Plastic Shield Installation - Echo SRM-3400 Operator's Manual

A
SSEMBLY
/
DRIVE SHAFT POWER HEAD
Tools Required: 8mm x 10mm Open End Wrench, 4 mm Hex
Wrench
Parts Required: Power head, Drive shaft Assembly
1. Stand powerhead upright on a level surface.
2. Loosen, the two (2) bolts at engine drive shaft clamps, and
remove center drive shaft location bolt (A).
3. Carefully fit driveshaft assembly to engine making sure that
inner drive shaft engages into clutch mount..
NOTE
Lower bearing housing and head assembly must be in line with the
engine.
4. Turn drive shaft housing until locating hole lines up with location
hole in clamp and install center drive shaft location bolt (A).
5. Tighten two (2) drive shaft clamp bolts (B).

PLASTIC SHIELD INSTALLATION

(for Nylon Line Operation)
Tools Required: Screwdriver.
Parts Required: Plastic Shield, Shield Plate, three (3) 5mm x 18mm
screws.
NOTE
The plastic shield is for use with the Nylon Line Head only. Install
Metal Shield when using plastic or metal blades.
1. Install the shield on the bottom of the bearing housing flange.
2. Place shield plate on shield, align holes and install three (3)
screws.
G T
RASS RIMMER
O
PERATOR
B
/B C
RUSH UTTER
' M
S ANUAL
A
A
B
11