Sony HT-K5 Operating Instructions Manual page 12

Installing the front speakers
on the ceiling/wall
You can hang the front speakers from the ceiling
or on a wall with hardware.
M8 screws
Attach the hanging hardware (not supplied)
on the top of the speakers.
Two M8 screws are already embedded in with
an interval of 100 mm on the top of the speaker.
Make sure the hanging hardware is match to the
interval of the screws on the top of the speakers.
Notes
• Use hanging hardware that is suitable for the ceiling
or wall material and strength. As a plaster board
ceiling is especially fragile, attach the hanging
hardware to a beam and fasten them to the ceiling
where reinforcement is applied.
• Contact the hanging hardware supplier or installer
regarding the ceiling, wall material and hanging
hardware to be used.
• Before installation, check the ceiling or wall to
ensure that it is strong enough to stand the weight of
the speakers. Sony is not responsible for accident or
damage caused by improper installation, insufficient
ceiling strength or improper hanging hardware
installation, natural calamity and etc.
GB
12
100 mm
Installing the surround
speakers on the wall
1
Prepare screws (not supplied) that are
suitable for the hole on the back of
each speaker. See the illustrations
below.
more than 25 mm
Hole on the back of the speaker
2
Fasten the screws to the wall. The
screws should protrude 5 to 7 mm.
5 to 7 mm
3
Hang the speakers on the screws.
Hole on the back of the speaker
more than 4 mm
4.6 mm
10 mm
4.6 mm
10 mm