Method Two - TP-Link RE210 Quick Installation Manual

Method TWO

Quick Setup Using the WPS (RE) Button
WPS is an easier way to extend your host network. You are recommended to use this method if your host router has a WPS button.
The button might look like one of these:
1
Power on
Plug the extender into a power
outlet near your router.
Wait until the LED turns
solid green.
3
Relocate
1
Plug in the extender halfway between your router and the Wi-Fi dead zone.
The location you choose must be within the range of your existing host
network.
2
Wait for the extender to reconnect and the
If not, relocate it closer to the router to achieve better signal quality.
Enjoy!
Both extended networks share the
Entertainment Adapter
The extender can be used as a wireless adapter to connect any Ethernet-only device
such as a Blu-ray player, game console, DVR or smart TV to your Wi-Fi network.
First, connect the extender to your router referring to Method ONE or Method TWO.
Then connect your Ethernet-only device to the extender via an Ethernet cable.
Frequently Asked Questions (FAQ)
Q1. My router has no WPS button, how do I connect the extender?
A. If your router does not support WPS, please use Method ONE to set up the extender.
Q2. How do I restore the extender to its factory default settings?
A. With the extender powered on, press and hold the Reset button until all the LEDs
turn on momentarily. Then release the button.
. Otherwise, please refer to Method ONE.
2
Connect
1
Press the WPS button on your router, and then press the RE button on your extender in 2 minutes.
2
If you are connecting the extender to a dual-band router but only
on, repeat Step 1 to connect the other band.
For more information about using WPS on your router, please refer to the router manufacturer's user guide.
Some ISP gateways disable the WPS function by default. If the WPS connection fails, please refer to Method ONE.
RE LED should turn solid green.
same network names (SSIDs)
Host Network
Router Ideal Extender Placement
passwords
and as those of your host networks.
Ethernet connection
Smart TV Game Console Desktop
Q3. What should I do if I can not access the web management page of the extender?
A1. If your computer is wirelessly connected, make sure that you have connected to the
extender's SSID.
If your computer is connected via an Ethernet cable, please make sure that the
connection is stable.
A2. Make sure your computer is set to obtain an IP address and DNS server address
automatically.
A3. Verify that http://tplinkrepeater.net is correctly entered in the web browser and
press Enter.
The LED should go from blinking
to solid after about 2 minutes,
indicating that WPS connection was
successful.
2.4G or 5G LED is
Extended Network
Clients
Router
©2016 TP-LINK