Rack Installation - TP-Link T2600G-28TS Installation Manual

Gigabit L2 Managed Switch
08
Installation
3. Turnover the device and attach the supplied rubber feet to the recessed areas on
the bottom at each corner of the device.

Rack Installation

■
To install the device in an EIA standard-sized, 19-inch rack, follow the instructions
described below:
1. Check the grounding and stability of the rack.
2. Secure the supplied rack-mounting brackets to each side of the device with supplied
screws, as illustrated in the following figure.
T260 0-28
TS
3. After the brackets are attached to the device, use suitable screws (not provided) to
secure the brackets to the rack, as illustrated in the following figure.
Caution:
Please set 5~10cm gaps around the device for air circulation.
■
Please avoid any heavy thing placed on the device.
■
Please mount devices in sequence from the bottom to top of the rack and ensure a
■
certain clearance between devices for the purpose of heat dissipation.
Figure 2-1 Desktop Installation
Figure 2-2 Bracket Installation
T260 0-28
TS
Figure 2-3 Rack Installation
Feet
Bottom of the
Device
Notch
Rack-
mounting
Bracket
Screw
Rack