Using The Osd; Accessing The Menu System - Dell 2407WFP User Manual

B
PIP / PBP Select
C
OSD Menu / Select
D
,E
Down (-) and Up (+)
F
Power button
(with power light indicator)

Using the OSD

Accessing the Menu System
NOTE: If you change the settings and then either proceed to another menu, or exit the OSD menu, the monitor automatically saves those changes. The
changes are also saved if you change the settings and then wait for the OSD menu to disappear.
1. Push the MENU button to launch the OSD menu and display the main menu.
Main Menu for Analog (VGA) Input
Or
Main Menu for non Analog (non VGA) Input
NOTE: AUTO ADJUST is only available when you are using the analog (VGA) connector.
2. Push the and buttons to move between the setting options. As you move from one icon to another, the option name is highlighted. See the
table for a complete list of all the options available for the monitor.
3. Push the MENU button once to activate the highlighted option.
Use this button to activate PIP (Picture-in-Picture) / PBP (Picture-by-Picture) modes adjustment.
Pressing this button continually cycles the
messages corresponding to the mode selected.
→
The MENU button is used to launch the on-screen display(OSD) and select the OSD Menu. See
Use these buttons for navigating and adjusting the slider-bar(decrease/increase ranges) controls in the OSD.
The green LED indicates the monitor is on and fully functional. An amber LED indicates DPMS power save mode.
The Power button turns the monitor on and off.
monitor through the following modes : OFF- ->PIP- ->PBP. You will see the following
→

Accessing the Menu System